LLJ300 ALUMINUM CONTINUOUSLY EXTRUSION MACHINE
I. Description of the machine
1.1 The continuous extrusion equipment is to extrude the aluminum rod to generate high pressure and high temperature. Through mold extrusion forming, it can adapt to small-batch production of various kinds, and can also adapt to large-batch production.
1.2 Through the high-pressure and high-temperature treatment, the influence of defects (cracks, burr and so on) existing in the raw material on the finished products can be eliminated.
1.3 To increase the density. The finished products are extruded at high temperature and high pressure, so that the surface is bright and clean, and the dimensional precision is high.
1.4 The product does not require annealing, and the hardness shall be uniform. The extrusion process can thoroughly eliminate the problem of raw material joint, and the length of the required product is not subject to the restriction of the length of the raw material.
1.5 The floor area of the extrusion equipment is small, the installation and construction are simple, the energy consumption is low, and the labor intensity is low. The safety during the production process is high, and the production environment is clean, which completely meets the environmental protection requirements.
II. Technical Parameters.
Model of the host machine |
LLJ300 |
Nominal diameter of the extrusion wheel |
300mm |
Power of the main motor |
90kW |
speed range |
4-22.5rpm |
Overflow rate |
0 |
Installed capacity |
110kW |
Cross- section range of extruded products |
5-150mm2 |
Maximum width of the product |
40mm |
Max diameter of the circular |
25mm |
Average Productivity |
220kg/h |
Types of raw materials:
pure aluminum rod and aluminum alloy rod
The diameter: F9.5 or F12.5
Diameter deviation: ±0,2mm
III. Configuration